Belt loops
Fabric loops attached to the waistband of the pants to hold a belt in place.
Where it is used
Straps and Loops
p. 4- Prepare the loop piece in the same way.

Straps and Loops
p. 4- Turn the strap right side out using a safety pin or a long hook. Attach the pin to the seam allowance. Baste the seam and press the strap well.

Straps and Loops
p. 4- Fold the strap piece in half lengthwise, with the right sides facing in. Align the markings and match up the edges. Secure everything with pins.

Straps and Loops
p. 4- Sew a straight line 7 mm from the edge.

Securing Belt Loops
p. 43- Secure the belt loops by stitching them 0.5 cm away from the waistband seam.

Attaching Belt Loops
p. 40- Sew the belt loops onto the top edge of the pants, following the markings on both the front and back pieces. Use a seam allowance of 0.5 cm.

Preparation of Belt Loops
p. 15- Press the lengthwise edges of the belt loop to the wrong side, aligning the edges.

Preparation of Belt Loops
p. 15- Press the belt loop in half again, tucking the edges inside.

Preparation of Belt Loops
p. 15- Sew finishing stitches along the edges of the belt loop at 0.1 cm.

Preparation of Belt Loops
p. 15- Press the stitched belt loops.

Belt Loops Attachment
p. 16- Place on the right side of the back, aligning the ends of the loops to form a loop.

Belt Loops Attachment
p. 16- Topstitch the loops on the side edge of the back according to the notches on the side edge.

Related terms
applied toMain fabric